Help CenterHelp Center
Diagnostics to improve link quality and performance.
To detect underruns and overruns, use the lost sample
Set the transport data rate in blocks or System objects.
Use the Universal Software Radio Peripheral devices exploiting SDRu (Software Defined Radio USRP) System objects to measure and calibrate for transmitter/receiver frequency offset at the receiver using MATLAB®.
These two models show how to determine the relative frequency offset between two Universal Software Radio Peripheral (USRP) devices using Simulink®.
Downstream spectrum analysis of signals using MATLAB®, Communications Toolbox™ and DSP System Toolbox™. You can either use captured signals, or receive signals in real time using the RTL-SDR Radio, ADALM-PLUTO Radio or USRP™ Radio. You can change the radio's center frequency to tune the radio to a band where a signal is present. You can then use the spectrum analyzer to view and make measurements on the received spectrum.
Use Simulink® and Communications Toolbox™ to perform spectrum analysis of the downstream signals. You can tune the radio to a band where a signal is present by changing the center frequency. You can then use the spectrum analyzer to view and make measurements on the received spectrum. You can either use recorded data from a file, or receive over-the-air signals in real time using an RTL-SDR radio, ADALM-PLUTO radio, or USRP™ radio.
You clicked a link that corresponds to this MATLAB command:
Run the command by entering it in the MATLAB Command Window.
Web browsers do not support MATLAB commands.
Select a Web Site
Choose a web site to get translated content where available and see local events and offers. Based on your location, we recommend that you select: .
You can also select a web site from the following list:
Select the China site (in Chinese or English) for best site performance. Other MathWorks country sites are not optimized for visits from your location.
Contact your local office