To use the I/O mode features of the Communications Toolbox™ Support Package for USRP® Embedded Series Radio, the following MathWorks® products are required:
Signal Processing Toolbox™
DSP System Toolbox™
To work with the hardware-software co-design workflow, the following MathWorks products are also required:
To target the FPGA fabric on the device: HDL Coder™ Support Package for Xilinx® Zynq® Platform (requires HDL Coder)
To target the ARM® processor on the device: Embedded Coder® Support Package for Xilinx Zynq Platform (requires Embedded Coder, Simulink Coder™, and the ARM Cortex®-A support package)
Third-party tools required by the I/O mode features are automatically downloaded and installed during the support package installation.
To work with the hardware-software co-design and FPGA targeting workflows, you must manually install the following third-party tools:
Xilinx Vivado® development tools, version 2018.2
|Development Board||I/O Peripheral Support||Hardware-Software Co-Design Support|
 USRP, USRP2, UHD, and Ettus Research are trademarks of National Instruments Corp.