This is machine translation

Translated by Microsoft
Mouseover text to see original. Click the button below to return to the English version of the page.

Note: This page has been translated by MathWorks. Click here to see
To view all translated materials including this page, select Country from the country navigator on the bottom of this page.

Spectral Analysis with RTL-SDR Radio

This example shows how to use the RTL-SDR radio, with MATLAB® and Simulink®, as a data source for downstream spectrum analysis. You can change the radio's center frequency to tune the radio to a band where a signal is present. You can then use the spectrum analyzer to view and make measurements on the received spectrum.

This example is implemented in two versions:

The following text describes the Simulink version, but both versions have the same functionality.

Overview

The model performs an FFT-based spectrum analysis at complex baseband, and provides the following graphical information:

  • A view of the spur-free dynamic range of the receiver

  • A view of the qualitative SNR level of the received signal

Structure of the Example

The following figure shows the receiver model:

Running the Example

When you run the example, you can measure signal characteristics such as peaks, occupied bandwidth, adjacent channel power ratio, harmonic and intermodulation levels, and spur-free dynamic range.