Before you can start using Communications Toolbox™ Support Package for Analog Devices® ADALM-Pluto Radio, you must:
Install this support package by following the instructions in Install Support Package for Analog Devices ADALM-PLUTO Radio.
Establish communication between the host computer and the radio by following the steps outlined in Guided Host-Radio Hardware Setup.
configurePlutoRadio | Configure ADALM-PLUTO radio firmware |
findPlutoRadio | Report information about attached radios |
sdrdev | Create radio object for specific radio hardware |
comm.SDRDevPluto | Create object for Analog Devices ADALM-PLUTO radio |
Get an overview of supported hardware and required software products.
Install Support Package for Analog Devices ADALM-PLUTO Radio
Install the support package by using the Add-On Explorer.
Guided Host-Radio Hardware Setup
Follow an automated hardware setup process to establish communication between the host and the radio hardware.
After you have successfully installed the support package, you can do any of the following:
Setup for Two Radios Connecting to One Host
Set up two radio hardware devices connected to one host computer.
Uninstall the support package using the Add-On Manager.
Resolve issues encountered while installing or using the features of the support package.