Detect the buttons pressed on a LEGO Remote Infrared beacon, measure the beacon proximity and heading, or measure the object proximity.
Simulink® Support Package for LEGO® MINDSTORMS® EV3 Hardware
Detect the buttons pressed on the Infrared remote, measure the beacon proximity and heading, or measure the object proximity.
The block output emits values as int8.
During simulations without hardware, this block emits zeros. See Block Produces Zeros or Does Nothing in Simulation.
Select the EV3 sensor port to which the sensor is connected.
Avoid assigning multiple devices to the same port. The options are
Select the required mode of operation for the sensor. The supported modes are:
Remote - Set this mode when you want the block to output the ID of the button pressed.
0 = No button, or Beacon Mode is off
1 = Button 1
2 = Button 2
3 = Button 3
4 = Button 4
5 = Buttons 1 & 3
6 = Buttons 1 & 4
7 = Buttons 2 & 3
8 = Buttons 2 & 4
9 = Beacon Mode is on
10 = Buttons 1 & 2
11 = Buttons 3 & 4
Beacon Proximity - Set this mode when you want the block to output the proximity of the beacon in percentage and the heading with the values in the range –25 to 25. Put the remote to Beacon mode for this operation.
Proximity - Set this mode when you want the block to output the proximity of the object placed in front the IR sensor in percentage.
Update this value to match the channel setting on the EV3 Infrared
Beacon. This parameter appears only when you select
Proximity values in Mode parameter.
Specify how often the block reads sensor values.
Smaller values require the processor to complete the same number of instructions in less time, which can cause task overruns.