Communicating with LEGO MINDSTORMS EV3 Hardware
This example shows you how to tune the parameter values of and monitor the signals from an algorithm running on LEGO® MINDSTORMS® EV3 hardware.
When you are developing algorithms, it is often necessary to determine appropriate values of critical algorithm parameters in iterative fashion. Simulink's External mode feature enables you to accelerate the process by letting you change certain parameter values while the model is running on target hardware, without stopping the model. When you change parameter values from within Simulink®, the modified parameter values are communicated to the target hardware immediately. The effects of the parameters tuning activity may be monitored by viewing algorithm signals on scopes or displays in Simulink.
This example introduces the Simulink External mode feature by showing you how to:
Configure communications between Simulink and LEGO MINDSTORMS EV3 hardware
Tune parameters of an algorithm from the same Simulink model that is running on the LEGO MINDSTORMS EV3 hardware
Use Simulink scopes to monitor results from an algorithm running on LEGO MINDSTORMS EV3 hardware
We recommend completing Getting Started with LEGO MINDSTORMS EV3 Hardware example.
You will need the following hardware:
LEGO MINDSTORMS EV3 Brick
EV3 Wi-Fi® Dongle or USB Ethernet Adaptor (Recommendation: Apple USB Ethernet Adapter)
Task 1 - Set up the Network Connection
Please refer to Task 1 and 2 in Getting Started with LEGO MINDSTORMS EV3 Hardware example and make a note the IP address of the EV3 brick.
Task 2 - Monitor and Tune Your Simulink Model
1. Open the
ev3_communication Simulink model.
2. In the Hardware tab, click the Monitor & Tune button.
Task 3 - Communicate with the Model
This task shows you how to tune the parameter and monitor the execution of hardware from the model.
1. Open the Scope block. The scope displays the value of signal from the left button on the EV3 brick. Press the left button. The scope shows the value of the signal change from 0 to 1.
2. Double-click the Frequency block in the model and change the value of the Constant value parameter to 600. When you click OK or Apply, the tone coming from the speaker of EV3 brick changes
Task 4 - Stop Communication
1. Click the Stop button in the Simulink model. This stops both the application on the EV3 brick and the simulation on your host machine.