Main Content

Trimming and Linearizing Simulink Models

This example shows how to use Simulink Control Design from the command line by linearizing a watertank Simulink Model feedback control system. An open-loop linearized model of the watertank will be extracted at an operating point where the tank level is at H = 10. The following 3 steps linearize and analyze the water-tank model.

For more information on programmatically specifying:

Step 1: Configuring Linearization Points

Open the model.


The linearization points specify the inputs and outputs of a linearized model. To extract the open loop linearized model, add an input point at the output of the Controller block and an output point, with a loop opening, at the output of the Water-Tank System block.

Specify the input point.

watertank_io(1)=linio('watertank/PID Controller',1,'input');

Specify the output point with a loop opening.

watertank_io(2)=linio('watertank/Water-Tank System',1,'openoutput');

The linearization points can then be set and viewed in the model.


Step 2: Computing and Specifying Operating Points

This next step involves finding an operating point of the Simulink model 'watertank' so that the level of the tank is at H = 10. One approach is to simulate the model then extract the operating point when the simulation is near the desired value. The command FINDOP will simulate a model and extract the operating points at times defined in the function call.

opsim = findop('watertank',10)
 Operating point for the Model watertank.
 (Time-Varying Components Evaluated at time t=10)

(1.) watertank/PID Controller/Integrator/Continuous/Integrator
      x: 1.69         
(2.) watertank/Water-Tank System/H
      x: 10.1         

Inputs: None 

In this operating point, H is not at the desired value of 10. However, you can use this operating point to initialize a search for the desired operating point where H = 10. An operating point specification object allows you to specify the desired value of H = 10.

Create an operating point specification object.

opspec = operspec('watertank');

Initialize the values of the states of the operating point specification with the ones in the operating point opsim.

opspec = initopspec(opspec,opsim);

The specified operating point can then be searched for (trimmed) using the FINDOP command.

opss = findop('watertank',opspec);
 Operating point search report:

 Operating point search report for the Model watertank.
 (Time-Varying Components Evaluated at time t=10)

Operating point specifications were successfully met.
(1.) watertank/PID Controller/Integrator/Continuous/Integrator
      x:          1.26      dx:             0 (0)
(2.) watertank/Water-Tank System/H
      x:            10      dx:      -1.1e-14 (0)

Inputs: None 

Outputs: None 

Step 3: Linearizing and Analyzing the Model

You are now ready to linearize the plant model by using the LINEARIZE function.

sys = linearize('watertank',opss,watertank_io);

The resulting model is a state space object that you can analyze using any of the tools in the Control System Toolbox software.


Close the Simulink model.


Related Topics