Board IP address

Setting the IP address of the board

Model Configuration Pane: Hardware Implementation / Simulink or Embedded Coder Hardware Support Package / Hardware board settings / Target hardware resources / Ethernet

Description

Use the Board IP address parameter for setting the IP address of the board.

Settings

192.168.1.10 (default)

Set the board IP address according to these guidelines:

  • The subnet address, typically the first 3 bytes of the board IP address, must be the same as the first 3 bytes of the host IP address.

  • The last byte of the board IP address must be different from the last byte of the host IP address.

  • The board IP address must not conflict with the IP addresses of other computers. For example, if the host IP address is 192.168.8.2, then you can use 192.168.8.3, if available.

Note

This parameter is available only when DHCP settings are disabled.

Recommended Settings

No recommendation.

Programmatic Use

No programmatic use is available.

Version History

Introduced in R2014b

See Also

| |