To set up a cluster, you first install MATLAB® Distributed Computing Server™ (MDCS) on a node called the head node. You can also install the license manager on the head node. After performing this installation, you can then optionally install MDCS on the individual cluster nodes, called worker nodes. You do not need to install the license manager on worker nodes.
This figure shows the installations that you perform on your MDCS cluster nodes. This is only one possible configuration. (You can install the cluster license manager and MDCS on separate nodes, but this document does not cover this type of installation.)
Product Installations on Cluster Nodes
You install Parallel Computing Toolbox™ (PCT) software on the computer that you use to write MATLAB applications. This is called the client node.
This figure shows the installations that you must perform on client nodes.
Product Installations on Client Nodes
Install the MathWorks products on your cluster as a network installation. You can install in a central location, or individually on each cluster node.
If you need help with this step, you can find instructions for this release at Installation, Licensing, and Activation in the Documentation Center. These instructions include steps for installing, licensing, and activating your installation.
Note MathWorks highly recommends installing all MathWorks products on the cluster. MDCS cannot run jobs whose code requires products that are not installed.
On the client computers from which you will write applications to submit jobs to the cluster, install the MathWorks products for which you are licensed, including Parallel Computing Toolbox.
If you need help with this step, you can find instructions for the current release at Installation, Licensing, and Activation in the Documentation Center. These instructions include steps for installing, licensing, and activating your installation.
When the cluster and client installations are complete, you can proceed to configure the products for the job scheduler of your choice. Use one of the following chapters in this document to complete your configuration and to test the installation:
Note You must use the generic scheduler interface for any of the following: